Last weekend I got my gas bottle back, and that meant green light for welding again.



There were three tis kind of holes in the joint of floor and sideskirt/panel.



One of previos type of holes fixed.



This how I made one spot. The inner side from thicker metal...



...and the out side from thinner sheet.



There was also a big hole in passengers floor. Some the joints were fine but some of them became pretty nasty, cause my lovely Esabs wire feed wasnīt partly working properly One of the causes might be the wire itself, because itīs two years old...

Today I started to put the interior back together. Only front seats are remaining, but I will install them tomorrow. Hopefully this car will be rolling in the streets next week, hopefully.