Started to make my own concentric hydraulic clutch set up,
Spent a long time looking for the correct bearing and slave cylinder as there's lots of photos if different supplied kits on the net but no part numbers etc
Sorted the cylinder, sorted a proper bearing for twin plate clutches, bought some billet to make the spacer,
Bored out the spacer so its a snug fit over the gearbox nose piece
Bearing press fitted on retainer
Spacer test fit
Just need to get my flywheel back so I can bolt up the clutch pack and test fit to work out spacer height, then the spacer can be turned down, drilled and threaded for the bolt holes and an anti rotation fixing
When I did a MT75 front nose mod I welded three sections on the nose piece and tapped it to take the spacer and tilton slave I had at the time.
I have one of these ford cylinders, had i for years but dont know what its off, did your round release bearing just press onto the std ford bearing carrier? what cylinder is yours off?
Do you recognise this?
