took my car to the dyno yesterday for a safety check to see how it performed under load, didnt get to complete it as it was detonating and air fuel ratios were around the 13, i was concerned with the detonation and lean running of car and asked the tester to stop!,

i now need a management solution anyone used boost monkey's ofam? apparently runs a ms2 board so its got to be a winner?....

other than that i have a emerald ecu lined up but not a clue what spec it is, it was run on a 20vt vw which has independant coils unlike the zetec so not sure if it has the compatibility for zetec and it requires a looom being made up

or a dastek unichip piggybank on a loom to fit ofab but how good arethese?