sorted it this morning. It was something i done I swapped pin 10 on the edis to pin 11 as i thought i read that it was the feed for the rev counter and thought that would run the rev counter I went through the wiring diagram last night and found out its actually a feed for the coil pack lol. I did wonder why the rev counter wasnt working lol so i put pin 10 back and ran a wire from 11 to the rev counter the car runs and ive got a rev counter However i did find another problem when the engine is up to temp it dosent idle properly it hunts between 500 rpm to 1000 rpm i think it may be a vac problem as ive fitted a dump valve and it dosent seem to be working. Also when i scanned the car im getting fault codes sayin 059 REMCO im not sure if this is something to do with the CO adjustment and also 024 air charge or air vane temp i think this might be something to do with the act sensor in the inlet manifold i have used one from a fiesta rs turbo but it was second hand. Could be ive got the wires the wrong way round on the sensor would that make it not work properly? Oh and my rad is leaking lol