If you are not confident to solder in the ecu send it to msd to fit, then everything else is plug and play, a sub loom connects to the ignition amp plug and this has 2 plugs for dual ignition amps, a coil pack plug and a couple of wire to add to the ecu plug, think 21 for rev counter feed and 26 for 2nd coil trigger. May need to mod your rev counter but mine was ok. You also remove the capacitor from ignition coil feed and connect 2 original coil leads together, but that's about all there is to it apart from removing old distributor cap and rotor arm and leads. The blanking cap for distributor is worth getting as well.