hi all. chris and i have decided to put both projects under one so it is easier to keep up to date. both will be done at the same time so makes more sense.
anyway not had much time spare lately so managed a few hours today.
still waiting for chris's shell to be delivered over which should have been this weekend. guess what, let down again. i knew i should have hired a trailer myself.
decided to start on preping some of the parts ready for primer. currently got the following parts sorted
2 bonnets,
1 door
1 set of sideskirts / arches
fibreglass bumper for chris, he had done a fair job already
2 rear spoilers.
one of the bonnets was pretty good with a few marks around the edges from storage i guess and a couple of low spots which were filled. the edges taken back to metal, rust proofed and primed.
the other bonnet was a different story. totally back to bare metal, several areas quite badly dented so filled again, rustproofed and primed.
the door wasn't too bad only a couple of small dents so filled and primed.
spoilers were good just a bit fiddly but came up very well although according to paint layers both had been resprayed atleast 3 times.
sideskirts and arches very good with no problems.
couple of pics. only applied primer where metal had been exposed.











all ready to sand down and prime properly when i get the chance. at least for now they are protected
need to get these finished now and stored away from any harm. don't want to fill more dents.