Originally Posted by
ELFRANCO
James if your not going to use them cut them out with a hacksaw or small grinder with cutting disc.....
i want to reuse them frank ,as their in good condition
Originally Posted by
doga-ot
you need a large socket short piece of 10mm stud sum washers and nuts and grease/wd40!
put a nut 1 end of stud put stud through socket then through bushnow washer goes on and nut now tighten up nut on the socket side until it pulls through same procedure to fit but use the grease/wd40 as lubrication first
WES
cheers wes ,i have use of a 50 tonne press so just lubricate first and then just press out
thanks mate
