Originally Posted by
dean richardson
Thanks for the advice
and my seats arn't that bad just worn on the drivers bolster the foam is ok just wanted it patched up . But if it is going to be a nightmare then I will just try and find some seats that are in better condition
If its just the bolster cloth thats worn, not the pattern stuff then any good trimmer should be able to match it from stock.
Had my 3i seat repaired when the foam had gone and started to flatten the cloth. Looked like new when he'd finished. Used a slightly firmer foam too and added a backing to stop it happening again too quick. Same with underneath where the support wires were cutting into the foam base.