been over today and stripped off old wing. temp fitted new one and it looks like it all lines up correctly.

thought i would try fitting everything round it and seems good.

fitted bumper but no go there. measuring the bulkhead to lower panel seems to be 5mm nearer on ns compared to os. the slam panel is about the same and also down by 2/3mm on ns. the side bumper bracket is also around 3mm back on that side. the cross member itself seems ok as measuring correctly on both sides. i think that means new inner wing will be needed. i could put on the 2 front panels and weld to suit. then the headlight brackets don't fit so where do i draw the line. at the end it has to be right so will be done right.