Hi there, just to clarify I have what was a standard 1.8 focus zetec collection. But now have st170 dials as I wanted to increase the rev limit on the dials as my engine limits at 7200 now and they look smarter and have a slightly higher top speed. They operate fine in every way other than the backlight as such doesn't work. The needles light up but the actual dials themselves don't, there is a two pin plug on them which isn't plugged in as that is part of the st170 loom which I believe is connected to the oil temp/pressure gauges. I just need to know what pins I need to connect to the oil gauges in order to make these light up or something alternative to make them work. I've seen a few bits of info scattered about but nothing conclusive. Heeelp! Thanks, Ali.