i started to remove the brake lines, i rounded over the front lines so no dirt gets in there before i fit the new lines.



looking less clutered after i removed the cluch pipes and brake lines.

i also dismantled the brake cylinder to see where it was leaking from, needed to know if i had to buy a new one.
i found a dodgy seal hmmm

so i removed the seal and cleaned it in the kitchen sink. before i cleaned it i blocked up the holes in the cylinder so they dont get any dirt in there

fitted to the servo again to stop dirt

im goin to need a new tank though its very shabby and the fitment to the cylinder is slightly damaged so dont want to chance it back on the car

here are some pics of the broken seal



other than ford are they for sale anywhere else?