[quote=parrot;5925313]
Originally Posted by
750hp escos
Oh I see what you are saying.
The spec is :
Siemen 55lb injectors
MSD Closed Loop chip
L8 Ecu
3 bar map
Compression 7:19:1 ratio
T34 with 48 housing
500 intercooler
BD10 Inlet standard exchaust.
It was setup before the build on Dark Greens and on a collins chip L8 ecu, which was a nice setup, then after the build put the MSD chip (closed loop) and new injectors in to run it in....
Now running the above new spec in and had a nightmare yesterday with white smoke pouring out, and then it cleared by itself........slightly worried. Have been told it may be internal water leak????
Well the chip and set up if all running right should be fine to just run with around 10 psi boost mate..
If the engine isnt losing water then theres no water leak if it is then its either h/g leak or head cracked or even worse the block is cracked..
Are you using the same head and block as before??if so then i cant see theres a problem there..
cheers danny