Originally Posted by
Versus_Creations
To set boost levels and characteristics is very easy.
Firstly remove all jets from amal valve and get the boost to hold 12psi with a -31 actuator.
Then you will need a 2mm jet in the Compressor side of the amal valve.
Also a 3mm jet in the Return side.
This will give aprox 18psi on most T3 turbo's like std erstt3, 2wd, 4x4 or anything inbetween.
If its too much boost you could take half a turn off the wastegate arm. Or if not enough then wind in half a turn.
Regards
Jano
hi! thanks for the reply my problem is that i had a t3/t4 and boost starts to come in on 4500 rpm its very laggy i am going to fit the standard t3 that y have, i am running Ms2 Managment is there any especific thing y have to touch on megasquirt to get it punchy?
Thanks!!!
PD: i dont have a amal valve fitted.