Finished wiring in my 600 and connected it to my laptop etc.

On the first start parameters have all reading properly apart from my crank position! No rpm when cranking, no spark, no fuel.

Have got a cossy sensor (vr type). So no jumpers on the main board. Showing 660 ohms through the sensor and between 1.8v and 1.3v when turning the engine over.

Set the crank position options to- lo gain above 2200, high gain below 1900, failing edge function and 50ms delay.

Still nothing, checked the wiring and the sensor connects to the right pin on the omex, read the manual (last resort) and still nothing!!

Any help would be wicked, omex are shut for the long weekend so I'm counting on you guys!

Cheers, Shaun