Atlas Axle Rebuild - Help
Hi
Just replacing the Salisbury axle with an Atlas from a Mk3 Capri. I have to reduce width - no problem - and fitting all new LSD, drive shafts, CW & P + bearings.
I am trying to find any instructions of how to rebuild the axle, in particular with all the new bits, of where to start with the pinion shaft. Do I "Dry" assemble with zero shims behind the bearings? and then work out shims required by measurement to get the correct contact between the teeth. What is the recommended torque for the nut on the pinion shaft fitted with the crush spacer?
ANY help - details appreciated. Its all for a Marcos V6 I use for Hillclimbing and do all the work myself.
Is there any articles in the "Gold" section before I spend my £10?
Peter
Last edited by Marcos V6; 03-05-2012 at 11:33 AM.
Reason: added to