you could always contact audi sport and hand over the national debt for originals lol


make sure the panel are coated black in 2k
then wet the panel with laminating epoxy
drape the carbon weave over the panel
gently bristle the weave with a wet epoxy brush to bond to the panel
leave to dry
the weave will exspand a little whilst drying
once dry coat the panel until the resin fully covers the weave
wet sand the panel starting with a 320 moving through the gradiants until 1500 BUT be very careful not to run through the weave just the resin as you always coat more resin not put carbon back
once 1500 grit has been used then use a g3 followed by a g10 to buff or from the flat finish laquer with 2k

hth mate