Originally Posted by
Fezman1
Top and bottom rad pipes - correct.
The waterpump secondry take off (20/25mm) is heater matrix
Turbo banjo on the outerside connects to header tank
Turbo banjo inner connect to small outlet of thermostat
Rear of head inlet side goes to the modine & the other one from the modine to the heater matrix
This is for the set up in a cossie running a heater matrix
Hope it is of some help
Yes thank you. So, if i'm not running a heater do i block the 20/25mm on the water pump? if so, do i also block the modine? or, can i connect the inlet at the rear of the head to the lower inlet on my header tank? Is there no cold start bypass?
Scott