Hello to everyone. I am building a kitcar (Haynes Roadster) using Ford Sierra drivetrain and an MV Agusta F4 1000 engine!

Yesterday i concluded the refurbishment of my Sierra driveshafts and CV joints.
A good clean and powdercoating and they look as new.
The problem is that when i bought my Sierra diff and driveshafts, these were dissasembled, i mean the diff had not the driveshafts bolted on but seperate.
As you can see in the pics below, one face of the shaft has a "star" stamped on it while the other has a number of circular marks. The question is which face goes to diff side and which goes to hub side? i remember reading somewhere that if you install them the wrong way around, they tend to break!
I have ordered a Sierra Haynes manual but if you could help me until it arrives, it goes well.
Any help greatly appreciated! Thanks!









[Edited on 7/1/12 by DRCorsa]