Thread: JIC fitting to Fuel Rail - Cosworth
View Single Post
Old Nov 5, 2011 | 10:35 AM
  #3  
chrisa3's Avatar
chrisa3
I've found that life I needed.. It's HERE!!
iTrader: (1)
 
Joined: Nov 2008
Posts: 1,163
Likes: 5
From: Newcastle
Default
Originally Posted by ian sibbert
Hi Pal,

I have done loads, cut the ends off the standard rail, that leaves square section hole, use a steel 9/16 JIC male/male machined down to slide inside the square hole, silver solder the gap, polish it up, job done...

Ian
Cheers for the reply. I was planning on using these, and just leaving 10-15mm of pipe pertruding from the original rail and sliding these over then soldering them?? would that not work?

http://www.ebay.co.uk/itm/6-AN6-Male...item2566c9a29d
Reply
0