Originally Posted by
dug112y
you say if you power up the fuse 8 by separate feed the lights work on lhs and when you take that feed away the light go out yet it still has 12v at the fuse?? is this correct?
if yes it could be a possible dry joint in fusebox that when under load is going open circuit.
Not quite, If i measure the voltage at the fuse to an earth, it reads at 12v wether the ignition is on or off. so if I run a wire direct from the fuse to the light it illuminates, wether the switch is on or off. yet whne i measure the resistance through the fuse box or the wires, then they are fine and read 0.00ohms, could it be the stalks as i did have a problem with only one side of the car illuminating when the hazards were one, though that seems to corrected itself.