Hi Everyone.

I've just changed my timing belt and tensioner and it's thrown up a couple of issues.

Firstly, the tensioner they (Ford) supplied me is different to the one that was on the car. After a bit of playing about it appears that the cam in the new one is 'turned round' 180 degrees if that makes sense.... (Should have took a photo with hindsight!)
To put it another way, to set the tensioner I found that I had to start with the hex key in the adjusting washer in the 10 o'clock position, as opposed to 4 o'clock as per the manual. Is this just a variation in the design or should I haver been a bit more worried?

Secondly, after 10 minutes or so of running the engine light on the dash came on.... I've put this down to the VVT being particularly sensitive to any alterations in timing. I was planning on checking the timing (have the plate and pin) and adjusting as necessary, although I did actually re-set it once when I changed the belt. Is it just a case of having to get the cams dialled in EXACTLY as they were? If so I'll perservere!

Much appreciated!

Mark.