http://cgi.ebay.co.uk/ws/eBayISAPI.d...#ht_2182wt_905

thinking of buying the above to help keep the heat of my engine bay down. i know im not running a turbo but i want to do it anyways as its good practice and should help in the long run. so far my 4-2-1 manifold is heat wrapped, and as a result of this ive had to remove the starter heatshield. this was the arrangement on my red one and i had no starter motor issues. i now want to heat wrap the inlet tube that goes over the top and some other bits. what would be the best way to fix this stuff? i was thinking of going the Araldite metal route but not sure how that works with heat resistance.

what do people normally do? i'd rather not rivet anything, especially since the inlet tube is plastic amongst other things.