ok folks ,

just looking for advice really , purchased fudgeys old pro alloy tanks for my cossie build , not 100 % sure on the fitting sizes ect till they arrive ,

but my question is this ......

what would be classed as the minimum amount of breather ports would you need for a 450 hp yb ?

and as a second part to the question , where the best loactions on the block to have currently i have a fitting welded in the sump , and breather returns either side in the block ,

the rocker could be drilled for an additional breather , but im looking for a super clan bay , and a very minimal look


so ideally the less the better but still allowing the motor to perform ....


anyone ?

pic of said breather ( as said till i get home i not sure if the two fittings on top are breather an fittings , )





beef