Sorry a bit slow to reply , forgot this was on going , I assume you have the 3 way plug up near the ecu plug that the suppressor goes into , if so there are 3 wires in it , a yellow one that comes from the MAP sensor and a brown/yellow that goes to pin 27 on the ecu , these need to be connected together .

I find it best if you make yourself a "jump lead" up , I make mine from a speedo sensor wire as it has the yellow wire in the correct position , then if you want you can just solder the green and yellow wire together and tape up in a termination bundle and tuck it away , what I do is make a small loom up using the yellow wire and plug , I remove the red and green wire , fit a Brown/yellow wire in place of the green , use a blanking grommet in the now spare hole , then solder the wires together and then heat shrink them , have an example pic if required as I did one today in case i decide to do a guide in the future .