Thread: Chip help
View Single Post
Old Mar 9, 2011 | 09:48 PM
  #18  
1stcoz's Avatar
1stcoz
15000
 
Joined: Feb 2011
Posts: 49
Likes: 0
From: uk
Default
Hi i got Stewart Sanderson to help me out and he was very helpful. I have a gt35 turbo with external wastegate big intercooler and radiator and this what he told me to get and i did. I trust him 100%. See what you think.


Ok, top of my head, If I were to take a standard YB and make it suitable for your turbo and 400+BHP I would lower the compression to 7.8:1 with pocketed pistons, fit a 3 port breather system, ported head and cometic headgasket. Then we would fit an uprated intercooler and radiator, finally, you’re ready to bolt on these parts:

Necessities:
BD 16 inlet cam.
Double valve springs so we can rev her to 8000rpm.

New followers BECAUSE we are going to rev her to 8000rpm
Plenum spacer to improve airflow through the inlet trumpets.

Bosch 044 pump and adaptor to fit direct to your car.
Engine & gearbox mounts to stop movement wrecking your DS joints.

3 bar map sensor:
83lb injectors

Dump valve: (necessity for GT series turbos)

Chip to your own spec
Reply
0