Thanks phill ,

when i spoke to kenny he asked what the ECU number was when it was a XR ,

i guess that there may have been a few varients .

as i didnt know he said to put the loom back to standard and to only move pin 27 to pin 8 , its a brown wire , surposidly for the co signal wire ??


now that u have mentioned it tho i have no adjustment for c/o at all , so will put that back to standard and see what happens .

i cant see how there has been so much confusion with these looms , surley the first couple of people to convert them would have sussed the correct pin changes , ( if any ) and spread the word ??????????????/

well get there ,


Bled the breaks through today and only have a very slight break , new servo is needed i think

Start running in this week fingers crossed ,

Couple o piccys for ya