Here's a little update of some of the bit's i have got so far
[/IMG] This is my inlet manafold witch will have a 2 ltr throttle body with a ford focus fuel rail and a power boost valve witch i already have...
[/IMG]
[/IMG]And this is my T04E T3/T4 Turbo on my old cvh manafold with the T3 flange i also have the adapter plate for this so i haven't got to drill and tap the zetec head..Witch will make my life a bit easyer when i build my engine up
[/IMG]Here's me magnecor lead's..But i need help cuz i dont no what the best spark plug's to use so if any one can help me it would be much appreciated
[/IMG]And here's my new lower arm's poly bush's and vibra technics gear box mount's
[/IMG]
[/IMG]As you can see by these last to photo's ive pulled my finger out of my bum and started on the back end by putting the polly bush's on and seeing if there's any welding need doing and surprise surprise the back rail either side where the top of spring fit's there is to bit's about 5 inch's.So the welder will be comming out at the weekend and i will be cutting out the rust and welding in some new plate.The only other thing i am worried about is when i take off the old under seal underneth is what else is it going to need welding as under seal seam's to hide alot of bodge job's up.SO I THINK ME WELDER IS GOING TO GET A LOT OF USE
But arfter this is done i can start on the rebuild of the 2 ltr engine,And fitting the pace rad, And proally front mount intercooler,And the rewire for the megasquirt witch ive got a lot of reading on how to set it all up,There's page's and page's that i have got to read through about sensor's, map's,crank setting's ignition setting's and on and on.Soon as i have any more photo's or if i have done any more work i will update thank's for looking..