Thread: Hart Plenum fitting problems **It's on, Finally!!!**
View Single Post
Old Oct 23, 2010 | 11:48 AM
  #25  
Sonic Boom's Avatar
Sonic Boom
PassionFord Post Whore!!
20 Year Member
Liked
iTrader: (11)
 
Joined: May 2004
Posts: 5,641
Likes: 33
From: Solihull near Birmingham
Default
Originally Posted by MadRod
Yes this is a problem that you either do properly or bodge.
Dont be stupid & bend brake pipes thats called a bodge & potentially lethal. You have to move the abs distribution block down an inch or so & re-pipe. Means drilling the inner wing, I have plenty of clearance after doing this even with a 14mm spacer. Surely you measured it before you bought it, I certainly did.
The brake pipe thing isn't an issue anymore i'm was going to make a new bracket for the Distribution block have it flat rather than with the bend it as it onlys needs about 3mm more of clearance.
The real problem is with the PAS pipe!
Rich
Last edited by Sonic Boom; Oct 23, 2010 at 12:07 PM.
Reply
0