I finished off putting the Dinitrol cavity wax in the front chassis legs and the inside of the front wing frame, also did the front bar that wraps around the radiator and the chassis where the subframe bolts to.

So 90% of the chassis is protected now, all that is left is to drill some holes under the back seat where the rear chassis beam goes across the car - spray in some Dinitrol and then re-seal.













Dinitrol give very good penetration, you can see below where all the Dinitrol finds every seam and runs through so i know the penetration is very good, a bit of cleaning up to do now though.....











I'm going to put Tigerseal on all the seams in a few days once the Dinitrol has thickened up a bit, i'm going to try to seal up EVERY gap along the whole chassis and floor to prevent any water ingress, it also makes the chassis look a whole lot neater as there won't be any gaps visible.
Its a real messy job but i think it's worth it in the long run.

cheers

Andy