Hi all

Hope someone can help, I have a sapphire 2wd, up till today it was almost standard except for exhaust, air filter etc.

Today I fitted a stage 3 chip, greens, 3 bar and actuator.

Now this is where some of you may cringe but I like to do my own work and mechanically I am quite adept but when it comes to the voodoo art of turbo and electronic set up I am a complete beginner.

My thoughts were Buy kit, fit and adjust boost then all should be hunky dori. However it does not seem to be the case.

At first major over boost, so I lengthened the actuator arm the point where the cut out stopped. Now it is as flat as a pancake.

In standard form it was loads faster so Something is deffo wrong.

Does the mixture need adjusting, or am I confusing it with my carb fed cooper engined mini. I would have thought that all would be automatically controlled by the sensors and ecu.

Hope someone can help.

Craig