Originally Posted by
BRAMMER
James I had also heard that, the reason I'm waiting to see what Danny gets out of there's.
Lee I will be speaking to the tuner soon but I think valve cutouts in standards is the way I may go, I think Harvey does it ???
My cam works for sure but im going to show everyone how well soon as im doing a std build just valve cut outs and a 3071 spacer on inlet and 83lbers and bench dynoed to prove ..
Will also book with harvey to do back to back on hes dyno even though its the same as harveys just to shut the doubters up....
Iv already seen 452hp and 440lb ft on my cam and that was at a 2 bar peak 1.9 bar held engine with very similar spec as above so it deffo works...
As for cr brammer just go cosworth or cp with std crown and then get cut outs machined and with a good deck head you will be circa 7.7-7.8cr wich will be spot on..
Any info or help and all you have to do is ask mate...
cheers danny