Hi there i,ve noticed this morning the o/s front bumper has dropped leaving around 1-2 inch gap ,just had a look thinking it was the support brackets or wing fixing that usually go but there all ok, so ive tried taking the whole bumper off to no avail due the 13mm n/s wing bolt just spinning . The actual problem is , is that the o/s bumper bar that goes into the chassis rail is rattling about , we tried adjusting this with the torx screw thats there but no joy.

How does the torx screw and square washer thingy in there too hold all this tightly? , is it a case of some wd40 in there to free it up so it can 'lock' in place. Due to the other side not coming off i cant see the other sides position , the bar has a good 2cm play in it up n down

cheers in advance