Originally Posted by
LHD220Turbo
get rid of the bleed valve completely, i assume you still have the amal valve?
you really need to know what the chip allows you to run before you set what the boost should be
i'd start from scratch with half preload on the actuator, just for piece of mind if not anything else, then adjust the actuator rod (shorten for more boost) as needed
yeah still got the amal valve. all i know about the chip is thts its a stage 1 and i read stage 1 should be set to 15psi so had it set to that. and had the actuator rod set so that half the hole at the end of the rod was over the wastegate lever so that i had to pull the rod over the rest of the wastegate lever. thats what i was previously told to do.. do i need to modify the amal valve at all or just connect it back up and adjust my actuator rod to the boost im needing?