JTFC

Just to clear things up, I purchased the ECU from TurboSystems who got it from MAD, supplied with a base map to get the car running. The car started on the 1st attempt. I then got the firmware version of the ECU updated to v1.09 and Mark didn't have a working base file for this firmware and my sensor setup, he changed a lot of the settings required when going from 1.07 to 1.09 but as with anything it is difficult to get these things 100% right without having the car in front of you to verify, the car didn't start after the firmware update so I played around with some sensor settings to get it running again. Mark hasn't done anything wrong, he's never even seen the car or done any work on it! He's always been helpful with any questions I’ve had.

I took it to TurboSystems to give the car a bit of a once over and to do a bit of work on the base mapping as it was stalling when revving the engine and coming off the throttle and the Idle was going abit mental from time to time, we have solved these little problems now, once I’ve got the car back on the road and run-in it will be going back to Tony for mapping as he is my preferred engine mapper, simple as that really!