Thanks for the advice guys - fuse 22 was the culprit!

Had checked it and it was ok,but it only made a connection half way out,when it was fully in it wasnt,so thats where i went wrong!

Many thanks for pointing me in the right direction!

HOWEVER,whilst replacing my heater matrix i noticed a burnt wire,so traced it back and replaced it through the loom,but it had melted into a few other wires.Its a yellow wire that goes to the abs ecu,and since getting it all back together i have found that the abs aint working right,typical!

Thinking about replacing the loom as i think its hanging on for dear life,and the wiring obviously aint right now for the abs - my question is what like a job is it changing the complete loom on these?? I think im gonna have to bite the bullet and just do it.

Again,any help appreciated!