Originally Posted by 155lee

yesterday i bought a rusty s2.it has had a bit of a bump and needs a wing,door and an x member.
how do you do the xmember?can it be done with the engine in?its got a bit of a kink in it so ill need to straighten it out then remove it for replacement.do you basically leave the rear arb bracket bolts in and remove the frontxmember 2 and when you fit the new 1 you put the bolts in and that lines it up?
drivers side rear floorpan,not the whole thing,just about 1/4 of it as where it attachec to the sill its gone.
rear drivers side arch.do you cut the old 1 off or fit the new 1 over the top and weld it every 2".also the edge of the inner arch doesnt look too hot,can you buy these from motor factors?ta,lee