harvcore

iTrader: (8)

with all the running gear done and car running i found a few problems ,i cut and shut a turbo exhaust to fit the std downpipe but its slightly off centre so will attempt it when i get the chance to put on a ramp as im fed up working underneath ,also the return fuel pipe i fitted from donor car started leaking so i fitted a lenght of fuel hose over it but it seems to keep blowing off ,so must need full new pipe without joins (can anyone confirm this )

anyway the bodywork was made ready for paint and there was only a few bits to fill around petrol cap (slight dent) and o/s lower rear sill ,had been plated previous so i tidied it up .

it was then etch primed and then primed again with regular primer