Right started on my new engine, I finaly got a block with standard bore size after looking all over it turned out it was out of a S1 as i found out later
got the engine back and striped it and cleaned it up. then i took it up to the machine shop to get the block and crank sorted, after telling them what i wanted i then sent the head off and orded some pistons and rods.
When i got everthink back and my new parts i took the bottom end to work to build it up.
what do yous think

took the old engine out and had abit of a clean




Then off to work to build the bottom end (My tools are better at work than the ones ive got at home)










also got my head back its had abit work done to it.
new big valve head