ok i just got hold of some air injectors which i would like to use with my S8
but i don't know too much about them and have some questions
i have done a search but found nothing
1. do i wire them in parallel in place of the AMAL?
2. how should i pipe them.
here is a pic, the 'jetted' red 'end cap' is on the right
does this side go to the compressor or the wastegate?
3. How much pre-load should i put on the actuator? 1/2 hole?
4. the S8 has settings for the boost control pulse width modulation of 8 Hz and 25 Hz which would be best?
5. where can i source some anodised push-on fittings to replace the shoddy plastic ones.
6. and any other stuff you can think of which might be of use...
Thank you