Water pump


remove belt


remove water pulley and powersteering pulley (may need to keep belt on to slacken nuts







clean with out marking surface


new pump on






VALVE CLEARANCES - 0.20mm / 0.008in

rocker shaft 5nm / 3.6lb/ft +50 deg , also double check the head bolts are '2 clicks clockwise' before fitting rocker cover


valves
8 open check 1
3 open check 6
5 open check 4
2 open check 7
8 open check 1
6 open check 3
4 open check 5
7 open check 2


rocker gasket


Then a good oil and filter change, as it will all be comtaminated from removing the head


New Clutch


remove interior and cowlings


remove gearstick


unbolt and swing hi/low gearbox selector foward to give clearance on seat box


slacken off gearbox and front diff breather pipes


unbolt front and rear propshafts (worst job on a landy)



undo the rear gearbox mountings


Use a suitable lift ()




Take weight of box and remove bellhousing bolts and nuts


swing box back to remove clutch etc


new clutch


this is the cause on a new clutch!!! see coin next to for size.
Was totally missing from the thrust bearing looks like the same chap installed this as who did the timing belt last time


new thrust bearing and sliders


Then its just a case of reassembling everything. Not easy when a certain tiger takes shelter fomr the wind next to you


take for a drive up to temp and give it the once over for leaks etc


done


Well that it folks, she is going back to france/spainish boarder on friday.

Thanks for reading

(ps dont forget my grey landy is up for sale now)