I'll tell ya what ive done now,

I made the intercooler on Krystis ka, from what i thought was a 2wd cooler, got the measurements of the end caps and designed new end caps to be cast so i could weld them on the cooler core and it would fit the KA like it was made for it.

(get me so far?)

Krystis car has been done for ages now and had no probs, and i get loads of emails asking me where did i get that cooler from, and can i make others for people to do the KA turbo conversion, so i thought id get some more castings made and get people that want a KA turbo intercooler to send me a "2wd" cossie intercooler to mod for them!

(think you know where this is going)

anyway....the first 2wd cooler comes through the post and i thought it looked a bit smaller than Krystis, luckily i realised b 4 i cut the ends off it.

Now i find out the intercooler i used for Krystis KA must have been a 4X4 one

The ends ive had cast are too big to fit the 2wd cooler

so

what do i do........

A ......... send the 2wd cooler back and get him to get me a 4X4 one
B ......... Get some end caps cast to fit the 2wd cooler

PS thanks for your help guys.....without you i wouldnt have found out that what i thought was a 2wd intercooler was a 4X4

PPS take it the 4X4 cooler is better lol?