Hi there, i recently broke my mk3 xr2i due to rusting ect so i took the following bits off to sell on.

2.0ltr ferriday block, if i remember rightly its a 1.8 cvh bored out, piston linners instaled and 2.0ltr zetec pistions. Cost me in the reigon of £1200 bare and the oil pump and water pump were replaced. There is just the shortblock with pumps for sale, and im looking for offers arround £750 ono.

1.6 Xr2i cylender head, ported ect done by mike at ferriday with piper cam, piper springs, ferriday solid lifters and steel valve caps, piper alloy vernier wheel. the cam is not the smoothest idler. This is the head assembly minus the rockers and other anccilerys which are available seperatly, looking for £400 ono.

The engine produced 153 hp@6500rpm and a rev limit set @7500rpm on ric woods rolling road and the operator stated it had tons of low down grunt, they also stated a good throttle boddy set up would see another big chunk of power as the ford system was holding it back.

Higher ratio roller rockers, incrase lift slightly, apparently give higher top power with a slight trade in low down grunt, not sure of the make. Looking for £175 ono

Xr2i magnex exhaust, quite old but in good condition, £125 ono

Power steering conversion for a mk3 fiesta, took me ages to find all the bits and made a big difference to the car, should fit all cvh equiped fiesta mk3s, all the bits are there but you may need some bolts and bits like that. Looking for £175 ono

Mk3 fiesta clear rear lights by i think M&W, excellent fit and quality, kite marked ect £60 ono.

OZ supaleggras 16" fiesta mk 3 fiesta with dunlop sp9000s, wheels are in decent nick, slight kerbing marks, tyres are ok but might need replacing in the future, theres a few marks on the tyres too, looking for £200 ono

Any inspections welcome, all parts are big heavy so cash on collection only, if you need any info or want to give me a ring pm me and ill give you exact address or telephone number ect via pm.

Chris.