Thread: Went to Power Engineering today
View Single Post
Old Jun 18, 2009 | 08:15 PM
  #1  
Paulo P's Avatar
Paulo P
PassionFord Post Whore!!
 
Joined: May 2004
Posts: 4,530
Likes: 2
From: High Wycombe, Bucks
Thumbs up Went to Power Engineering today
We went down Power Engineering today to see their new dyno in action and to get a few power runs

My mate Neil’s car











It made 545bhp with an exhaust blow, should have been more but Iain thought it felt short of ignition timing.

My mate Cliff’s car









Cliff’s car was suffering some detonation so Iain aborted the run

Mine













The figures for mine? I was expecting around 260bhp and 310lb/ft





Ignore the boost figure, unless the gauge is massively wrong in the car it was 1.2 bar



Well chuffed with those results and love the fact that you can get low cars on and off the dyno without issue because it is sunk into the ground.

Thanks Iain for the power runs
Reply
0