Hi all i have come across a few problems building my 3dr cosworth project wondering if anyone can help.

Question 1: Strut tops - i bought a twin bar strut brace which may have come off a sapph (i cant remember it was ages ago) but there's no way its fitting my 3dr, its a good inch too wide? I'm guessing the sapphs and 3dr strut top distances differ??

Question 2: ABS ECU - i am looking to use my old ABS ECU brain out of my sapph cosworth, will it be compatable with the 3dr ABS wiring, also it looks a real tight fit to get the ECU and ABS brain into the gap in the dashboard, i kept them all together from my sapph in the holder that holds them together but it doesnt look like its going to fit???

Quetion 3 (last one) i want to graft my 2wd sapph engine loom into my 3dr internal loom as its a reall good condition loom. Had a look under the dash and have found what i think is the connector but it only has 2 wires in it? Also the red and balck fuel pump wire (i think thats what it is) has previously been cut by the look of things and is hanging loose. Next to it is also a thin black wire also cut and hanging loose - i have no idea whay these have been cut and i can see the other ends?? Anyone got any ideas??

Sorry for writing war and peace but am struggling a bit at the moment

Cheers!!!!