Originally Posted by
B1G_RST
few bits of info needed for tapping into the exsiting loom/wiring,,
1.which relays which ? haha whats colour of the fuel pump relay and fuel injection relay?
2. pin 6 goes to the oil press sw, this the switch that the turbo braided hose goes into at back of block?
3. anyone no colour of ignition switch cable i need to conect into?
4. pin 3 go to the back of the rev counter aswell as a cable from pin 11 to the back of the cover?
cheers for any advice
Right, I'll have a go:
1. Fuel injection relay is a spst one
2. I can't completely remember where it comes out of but I'm sure you're correct.
3. Cant remember the colour off the top of my head, use an inline tester to look for the one that lights up the tester with the ignition lights on.
4. If you have a EFI dash then pin 3 goes to the rev counter. If you have a S2 dash then run a cable from pin 11 of the EDIS to the rev counter (You could cut the cable to pin 3 on the multi plug and replace it with a feed from pin 11 of the EDIS)
Lee
