I'm not driving to Bolton as well!

Got my rear seat fitted today.

Took the base plates off the Cossie foams.



Cut out the section that was catching the inner wing section and where the catch would need to go.



Cut the lock out of the ERST seat backs.



Marked up where it needed to line up and tack welded it.





Then welded it up and strengthened the rear



One pin needed to be exteneded to pull the foam into the back and a section of foam needed to be cut out for the lock to sit in.



And all fitted up





The other side is also finished, but by the time I finished it, it was too dark to photograph as this phone doesn't have a camera flash

I'm going to cover the backs in carpet so you wont see any of the welding. Should have them 100% finished on Wednesday.