Thread: Mk2 Fiesta trackcar,12/10/10 update,ST170 6 speed mounts
View Single Post
Old 05-02-2009, 07:51 PM
  #37  
GINGExR2 T
Advanced PassionFord User
iTrader: (1)
 
GINGExR2 T's Avatar
 
Join Date: May 2003
Location: South Wales
Posts: 1,702
Received 13 Likes on 13 Posts
Default
After the cross member was sorted i set about stitching the engine bay up, i also added 2 plates, 1 either side to join the inner leg to bottom mounting point box section so as to stiffen them up a bit, and i welded up all the small holes tah are not needed at the same time to tidy it up.

Before, if you look closely you can see the crossmember fixing sections on the engine bay side
Name: DCFC0006-1.jpg Views: 683 Size: 48.0 KB
Name: DCFC0005-2.jpg Views: 733 Size: 47.9 KB
Name: DCFC0001-5.jpg Views: 695 Size: 51.1 KB
Name: DCFC0002-4.jpg Views: 653 Size: 54.9 KB
Name: DCFC0003-4.jpg Views: 695 Size: 56.9 KB
Name: DCFC0004-3.jpg Views: 715 Size: 61.4 KB
Name: DCFC0007-1.jpg Views: 655 Size: 41.9 KB

after
Name: DCFC0001-1.jpg Views: 674 Size: 60.4 KB
Name: DCFC0003.jpg Views: 688 Size: 57.3 KB
Name: DCFC0004.jpg Views: 669 Size: 58.0 KB
Name: DCFC0005.jpg Views: 667 Size: 60.1 KB
Name: DCFC0006.jpg Views: 696 Size: 56.6 KB
Name: DCFC0007.jpg Views: 716 Size: 57.6 KB

Thats sorted, so i'll get it on it's side next and do the chassis rails under the car from the engine bay back.
Last edited by GINGExR2 T; 05-02-2009 at 07:59 PM.
GINGExR2 T is offline  
Reply Like