I found on mine I needed to increase the decay time considerably.
Just go to F8, look at temp on screen, then go to idle control make sure idle stabilisation using ignition advance is ENABLED, as this helps a lot.
Then go to inj corrections and note the values of each that you need, then you can adjust on F8, as this will have a LIVE effect, so say it responds better with 15 more on injection, look at temp and then you can add that to the table for injection correction versus temperature.
Do this on one map, that you can have as your play map, leave one std as it is, so you can always go back if necessary, if only using one map, get a switch so that you have THREE, and move map into all positions, to start with.
tabetha