Girlfriend bought me a toad ai606 alarm to keep me busy for a few days and I can well and truly say i dont know where to start.
I have read through the installation guide printed off the net and have labelled all the relevant wires accordingly, so i dont have to keep looking at the guide and to also give me an idea of how the alarm works.
Well i dont know where to start guys, I have been in there with a multimeter sorting the open door and close door circuits and think i need one wire on the microswitch and one on the light switch when door is open.
I sure on the obvious like, +12v and earth points but as for the rest its a mystery.
Have worked out the door locking system too I think, well i am going to connect one wire to door open and one to door closed but i dont know where the central locking door relay is so am a little stuck there.
Then we come to the immob system, need a live while cranking and am going to use the starter motor for that i think, then a few others. Toad have supplied a 4 branch connector plug for the immob system and was wondering which socket i plug each out put into.

If anyone can give me a hand on this Id be most appreciative, the sooner i get the alarm installed the better