right i need to time up my zetec, 2.0 blacktop, tried it the manual way using made up tools, got the cam timing right but the TDC of the block may not be 100%.....
the engine doesnt run half as well as it used to!!!! doesnt seem right at all!.

so....



i have this tooooool with two threaded bar thingys and the block that goes behind the cam.
but before i go off and have a crack at doing the timing, which bit goes where???
i know one pin goes in to lock the bottom end at TDC but what does the other pin do??

and which goes where????

and.... do i have to loosen the pulleys on the cam, and are these LEFT HAND THREADS as opposed to normal threads to loosen them???


plz help i want my zetec back up to power its definatley the timing btw!! compression test comes up perfect!!!